How to install frameless glass door hinges?

1. In a straight line. The method of measuring whether the coaxial line is available hammer line method.

2、Scribe a line inside the upper and lower horizontal stop of the door and fix the pin hole plate of the rotating pin and the rotating shaft coupling plate of the floor spring according to the line. Refer to the installation instructions attached to the floor spring for installation.

3. The toughened glass should be chamfered. And hit the hole for the installation of the door handle (usually when purchasing tempered glass, it is required to be processed. Note the height dimensions of the tempered glass, which should include the installation part inserted into the upper and lower transoms. Usually the cut size of the tempered glass should be less than the measured size of about 5mm, so as to make adjustments.

4. Install the upper and lower transoms in the upper and lower edges of the glass door and measure the height of the door. If the door height is not enough, that is, the gap between the upper and lower sides from the door frame and the ground exceeds the specified value. Wooden plywood strips can be placed under the glass in the upper and lower horizontal stops. If the door height exceeds the installation size, you need to ask the glazier to cut off the excess part of the glass floor bullet door.

5, after fixing the height, to fix the upper and lower horizontal block operation. The method is: in the tempered glass and metal on both sides of the gap in the upper and lower horizontal block, both sides at the same time insert a small wooden strip, and gently knocked into it, and then in the small wooden strip, tempered glass, the gap between the horizontal block injected glass glue.